Assembly Instructions
Features
STEP 1: PROTECTION
Remove plastic protector cap protecting the gland sealing surfaces. Go to STEP2A for Retainer Assembly, other go to STEP2B.
Remove plastic protector cap protecting the gland sealing surfaces. Go to STEP2A for Retainer Assembly, other go to STEP2B.
STEP 2A: RETAINER ASSEMBLY
Place retained Gasket over gland face. Be careful not to scratch or nick sealing surface as this could affect performance.
Place retained Gasket over gland face. Be careful not to scratch or nick sealing surface as this could affect performance.
STEP 2B: NON-RETAINER ASSEMBLY
Place Gasket into female nut.
Place Gasket into female nut.
STEP 3: FINGERTIGHT
Assemble components and snug to fingertight.
Assemble components and snug to fingertight.
STEP 4: MARK
Mark the hex flat on both the male and female nuts.
Mark the hex flat on both the male and female nuts.
STEP 5: TIGHTEN
Holding the backup wrench stationary, tighten the female nut 1/8 turn past fingertight.
Holding the backup wrench stationary, tighten the female nut 1/8 turn past fingertight.
.jpg)
沪 ICP备案 05032053
